Address Selection
In the BL-Ctrl V1.1 engine address is set via jumper on the board.
Where:
In this roadmap can be seen, among other things the addresses and locations of motor control, as well as the rotational direction of the corresponding propeller:
(Click for high resolution)
Pin assignment
Be soldered to the case of pre-populated BL-Ctrl V1.1 still needs the enclosed Elko:
It is recommended that the abzuwinkeln Elko by 90 ° so that it lies parallel to the outer side of the board.
Continue to recognize in the photo to connect the I2C-bus cables and power supply.
![/!\](BL-Ctrl_V1_1_files/alert.png "/ '\"){kind=small}
The controller is sensitive to moisture and should be shrink wrapped with shrink tubing!
Schematic
(Click for high resolution)
Bestückungsplan
Top:
Bottom:
Elkomontage and address label
The 2x5 post connector is one of several possibilities, the programming port making it available. This plug the controller with the will SerCon, ISP1 connected.