|
Click a link to support the forum
|
Loading
Written by Ziggy
March 11, 2012, 05:08:00 PM
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
PPM - sum signal |
||
|
Pad |
Function |
Cable color |
|
GN |
GND/Minus |
Black |
|
+5 |
Plus 5V |
Red |
|
PPM |
data connection |
Orange |
|
Click to enlarge the image |
||
Spektrum Satellite ReceiverThe 3,3V power connection for the satellite receiver is on the bottom side of the Flight Controller. Connection: |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Jeti Satellite ReceiverThe external diode is already integrated into the FC2.1 circuit and therefore will not have to get soldered. Connection:
Also see: JetiDuplex
HoTT ReceiverSince Software version V0.86 The HoTT receiver will also connected on the PPM and RX pads of the FlightCtrl. To send the telemetry a solder bridge on "JET" is needed. Connection:
Futaba S.Bus ReceiverSince Software version V0.88 A S.Bus receiver can be connected with a signal-inverter to the FlightCtrl. Connection:
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Related
- The How to
- The General Mikrokopter
- The Newbie
- The Radio Station
- The Hardware
- The 2.1 Mikrokopter Flight controler -FC
- Installing Recievers on 2.1 FC
- Navi Board 2.0
- Compass Calibration
- More Navi info SD card ect.
- Mikrokopter Software 88
- ARF Pre-build Testing flight Control and Power Dist board.
- ARF Navi board and GPS Pre build Testing.






