The instructions have one problem. they show the Xbee connected to the
FC port, it must be connect to the Debug port to make it work.
Now with 2.0 Navi and 2.1 GPS
Also comes with Water tight Airtight B&W Case..
Pictures to come..
Ziggy's Follow Me Kit 900Mhz
The Follow-ME-transmitter sends its own position 5 times per second as the target position for the MK.
In the NaviCtrl (on the FollowMe-Transmitter) a special firmware version is needed.
The NaviCtrl sends the position data simultaneously on the 10-pin "debug" interface and also on the 10-pin "flight control" interface.
The ZigXbee, on the Ground is connected on the NaviCtrl (on the FollowMe-Transmitter) on the "FlightControl" interface.
The Kit includes:
1- ZigXbee Pro 900 60 mW radio Module, Pre-configured to work with the ZigXbee Pro 900 systems.
1- Xbee regulator board, configured to work with the 900 Pro Xbee.
1- MKNavi-Ctrl V2.0
1- MKGSP V2.1
1- Navi Cable and parts kit
1- GPS Molex Cable
1- jst cable for connecting the lipo to the Navi
1 -Thunder Power 350mAh 3 Cell 45c Lipo with pre soldered Jst connector
1- ARCH_SR78-5S/1000 Voltage Regulator
4 -15mm stand-offs
4- 8mm stand-offs
4 – 3mm nuts
2 – three wire servo cables
For Xbee modules you connect them to the Debug portt on the Follow me unit..