The NEW ZigXbeePro 900 USB
The Only Complete USB Wireless Solution for your Mikrokopter.
Often imitated but Never duplicated..
True Plug and Play
Due to High Demand Please only one unit per order.
Pre-programed and ready to install.
Completly New Case Design!!
Zigxbee 900 Now comes with 2dBi Rubber Duck antenna for both the Kopter Side and the PC side.
Easier to mount.
Custom MKUS designed Strong light case.
Easy to route cables.
More protection for the kopter side Radio.
Easy to see the Tx and Rx lights on both sides.
New heavy duty connectors will not break off the board like ribbon Cable.
You Can upload GPS way-points to your MK in the air.
Get telemetry information such as height, GPS location and Battery Usage
Use the New Serial Features on the New Fight Controller software.
All through the Mktool OSD in Real-time..
No programing knowledge needed.
No soldering plug and Play!!**
Don't let their size and weight fool you!
These Xbee Pro 900 60 mW's* are rated at 6 miles with a high gain antenna
Highly used and proven in industry
The Usb ZigXbeePro 900 USB Tx Rx enclosures is made of tough ABS plastic and it has a removable 2.6G Dipole 2dbi Antennas with a Standard RSMA connector.
These can easily be upgraded with any off the shelf RSMA900 Mhz antenna.
*** Kit may look slightly different than the picture.
These are Programmed to only work with ZigXbee systems from MiKroKopter.US
Connect the Kopter side radio to the Navi Debug port,
Or if you are not using a Navi board you can connect it directly to the FC.
Connect the white wire to pin one vertically.
On second cable connect The Black wire to Pin 9 and Red to Pin 7 Horizontal.
The cut wires are not used.
Plug the USB cable into the PC side radio, plug into an available USB port on your computer.
Windows should then find the new USB to Serial Converter and create a new com-port #.
Power on the MiKroKopter.
Then Launch MKtools as you would normally. Making sure it switched to the correct com-port.
Sometimes you may have to reboot to release the old comport and restart MKTools to connect.
You should see a red glow showing the radio has power.
Once the Radios Sync up and you have a connection within the MKtool, you will see lights flashing
through the cooling holes near the Antennas.
"NEVER EVER UPDATE FIRMWARE VIA ANY WIRELESS DEVICE"
Always use an MKusb to update firmware.